13.56mhz high frequency RFID desktop reader OM-FR410C-H
IC card reader can set 5 output formats steps:
1. Use the IC card to set the output format, for example, the IC card number (called A card): B5 BB 23 FE (The sequence of the UID read by the NFC mobile phone software is opposite, we call it the reverse sequence, and the opposite is the positive sequence.)
2. If no IC card is detected within 1 second of power-on, the setting fails, and the output of the card reader is the card number in the current format.
3. If there is an IC card detected within 1 second of power-on, it will enter the setting state (it is best to place the A card within the card reader’s swiping range to power on), at this time the LED light keeps flashing (about 5 seconds), please click here Start setting within the time period.
1) Swipe another IC card (called B card) once, and then swipe A card or wait for 5 seconds, the card reader is successfully set up, and the output IC card number is 10-digit decimal reverse sequence: 3048940542 (8H10D, take 4 bytes converted to tens)
2) Swipe the B card twice continuously, and set the output card number to 8-digit decimal reverse order: 12264446 (6H8D, the last 3 bytes are converted to 8 digits)
3) Swipe the B card 3 times in a row, and the output card number is set to 8-digit decimal reverse order: 18709214 (2H3D4H5D, the second byte is converted to 3 digits, and the second byte is converted to 5 digits)
4) Swipe the B card 4 times in a row, and set the output card number to hexadecimal reverse sequence (8H or 14H): B5 BB 23 FE
5) Swipe the B card 5 times continuously, and set the output card number to hexadecimal positive sequence (8H or 14H): FE 23 BB B5
Fourth, swipe the third IC card (called C card) in the configuration mode, and the card reader is set to not bring a carriage return.
5. In the configuration mode, swipe the A card again to confirm and exit the configuration
